|
eMule佳礼讨论区 v0.49b (06/08)
[复制链接]
|
|
发表于 1-2-2007 12:21 AM
|
显示全部楼层
Status: Connected
Users: 1,493,038
Files: 253,611,710
ID: 3550687292
High ID
我一直都是这样。。。 |
|
|
|
|
|
|
|
发表于 1-2-2007 08:18 AM
|
显示全部楼层
我最近遇到 很多“Downloaded part 75 is corrupt”
不知为什么呢 |
|
|
|
|
|
|
|
发表于 1-2-2007 04:18 PM
|
显示全部楼层
什么主题? 有连接供参考吗? 
Downloads are about sources & luck, not about hardware.
To achieve such speeds you must run many downloads/sources and therefore if you don't control the number of maximum connections/rate at which they are made then your router will struggle. It is, however, quite possible to run enough sources to potentially achieve such speeds with some degree of consistency even with quite low simultaneous connections.
Possibly even more important is UL Limiting, which if not done correctly will have the effect you describe. When you attain a straight line on your upload graph then you know you are providing good quality uploads and your downloads are not being affected.
It is these two factors that are why you are still experiencing loss of connection.
Try the following settings:
Max Connections 200
Max New Connections/5sec 10
Max Half-Open Connections 9
UL Limit approx 75% upload bandwidth. If graph is wobbly then lower.
No more than 3000 sources total (guideline).
It should be noted that D-Links are known for their incompatibility with Kad (or rather the UDP packets it creates) and so using this network may also cause difficulty.
So, unless your router was faulty or unless it is simply a matter of circumstance (sources/luck), then I believe you could easily achieve have achieved these speeds with your old router with the correct settings (& not using Kad).
Finally, it's wonderful that you are now downloading so fast, but please consider the balance of the network and try to keep your UL L ratio either equal or in the favour of uploads. It won't be popular to boast of a ratio in favour of downloads!
原贴网址:
http://forum.emule-project.net/index.php?showtopic=119926 |
|
|
|
|
|
|
|
发表于 1-2-2007 07:20 PM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 2-2-2007 01:16 PM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 3-2-2007 03:07 AM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 3-2-2007 01:33 PM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 3-2-2007 02:14 PM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 3-2-2007 05:52 PM
|
显示全部楼层
我的也是...通常都发生在一些源很多的file。。 |
|
|
|
|
|
|
|

楼主 |
发表于 4-2-2007 03:40 AM
|
显示全部楼层
暂时原因还未明, 在台湾方面也有很多用户面对相同的问题..
有任何最新消息定会告诉大家.
- - - - - - - - - - - -
原帖由 迪岚 于 1/2/2007 04:18 PM 发表
To achieve such speeds you must run many downloads/sources and therefore if you don't control the number of maximum connections/rate at which they are made then your router will struggle. It is, however, quite possible to run enough sources to potentially achieve such speeds with some degree of consistency even with quite low simultaneous connections.
Possibly even more important is UL Limiting, which if not done correctly will have the effect you describe. When you attain a straight line on your upload graph then you know you are providing good quality uploads and your downloads are not being affected.
It should be noted that D-Links are known for their incompatibility with Kad (or rather the UDP packets it creates) and so using this network may also cause difficulty.
并不是KAD会拖慢下载速度, 而是因为一些router (比较旧的?) 无法承受KAD的连线活动, 像D-Links.. 造成router失灵. 
[ 本帖最后由 IK 于 4-2-2007 08:56 PM 编辑 ] |
|
|
|
|
|
|
|
发表于 4-2-2007 04:34 PM
|
显示全部楼层
|
|
|
|
|
|
|

楼主 |
发表于 4-2-2007 09:02 PM
|
显示全部楼层
原帖由 RB26DETT 于 3/2/2007 02:14 PM 发表
看運氣,有時候可以recover 90%的part,有時候recover不到。。。
RB26DETT, 可以帮我试看吗?
enable Neo的Argos anti-leech. 最新的antiLeech.dll v25 (23.01.2007), 可到此下载 http://www.xtreme-mod.net/.
原帖由 零.Vir 于 3/2/2007 05:52 PM 发表
我的也是...通常都发生在一些源很多的file。。
零, 也需要你帮忙测试.
update最新的IPfilter, 然后要记得勾filter servers too.
希望听到你们的好消息. 
[ 本帖最后由 IK 于 4-2-2007 09:26 PM 编辑 ] |
|
|
|
|
|
|
|
发表于 4-2-2007 09:42 PM
|
显示全部楼层
|
|
|
|
|
|
|

楼主 |
发表于 4-2-2007 10:10 PM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 4-2-2007 10:40 PM
|
显示全部楼层
原帖由 IK 于 4-2-2007 09:02 PM 发表
零, 也需要你帮忙测试.
update最新的IPfilter, 然 ...
我就快疯了。。。一直file corupted ..
scandisk deregment 全都试了。。。
我已试过把握的emule换去另外一个harddisk...
可是还是一样。。。
现在就去试好的。。 |
|
|
|
|
|
|
|
发表于 5-2-2007 02:34 AM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 5-2-2007 02:51 AM
|
显示全部楼层
|
|
|
|
|
|
|
发表于 5-2-2007 11:56 AM
|
显示全部楼层
昨天本来是high ID的
现在变成Low ID了
为什么会这样的? |
|
|
|
|
|
|
|
发表于 5-2-2007 12:33 PM
|
显示全部楼层

请问那个option要勾吗???
原帖由 DeclanLim 于 5-2-2007 11:56 AM 发表
昨天本来是high ID的
现在变成Low ID了
为什么会这样的?
restart router .. will do
今早我也是这样。。。 |
|
|
|
|
|
|
|

楼主 |
发表于 5-2-2007 03:34 PM
|
显示全部楼层
原帖由 RB26DETT 于 5/2/2007 02:34 AM 发表
我下載了antiLeech.dll v25,不過不會用。。。
对不起,对不起.. 我也是刚在office偷偷研究到了.
你只需要把下载的antiLeech.dll.new直接放入Neo>Config里就行了。重启Neo,它会自动更新。
原帖由 零.Vir 于 5/2/2007 12:33 PM 发表
请问那个option要勾吗???
预设 (default) 是有勾的。我指的filter servers too是在IPfilter那边的。 |
|
|
|
|
|
|
| |
本周最热论坛帖子
|