请问Focal FPS4160好吗？？

Reve1122

各位，小弟在此想请教各位Focal的功放好吗?新出的FPS 4160如何，在网上很少找到评语，所以想问问各位。之前已经花了很多钱，却一直找不到匹配的功放，之前换过了FLUX 2 channel,后来转active换FLUX 4 channel，后来又换去DLS，还是达不到我要的。本想换Alpine F6，可是又没货。DLS Ultimate A4, Mosconi AS100.4, Genesis P4U都在考量中，但个人觉得最搭配的可能还是原厂功放。小弟现在车上的setup有9887, Focal KR2, DLS RA40.



Description

High-end Class AB amplifier. Direct mode available for quality active amplification. Thermo-controlled ventilation. Compatible with High-Cap.

Technical specifications

High-pass filter	50Hz - 500Hz 500Hz - 5kHz
Low-pass filter	50Hz - 500Hz 500Hz - 5kHz
Remote control	Yes (channels 3-4)
Fuse(s)	2*40A
Nominal power measured at 14.4V continuously into 4 Ohms THD + N<=1%	4 x 120W (CEA 2006)
Input impedance	13kΩ
Signal/Noise ratio (RMS)	92dBA
Frequency response	10Hz - 52kHz (channels 1-2)
Input sensitivity	0.2V - 5.2V
Maximum cross section of power cables	35mm2 / 2 AWG
Protections	Short-circuit Thermal overload High voltage Polarity reversal
Dimensions (HxWxD)	59 x 429 x 254mm
Nominal power measured at 14.4V continuously into 2 Ohms THD + N <= 1%	4 x 200W
Power in bridged mode measured at 14.4V continuously into 4 Ohms THD + N<1%	2 x 380W

chin_siew

有时安装，调音和cd会是很大的关键。。
你的9887有加701吗？？

Reve1122

还没有，不过有打算下H800玩3 way

Reve1122

Whatever ohm rating you see on the amps will depend on the speakers. If your speakers are 4 ohm, when connected to the amp, the amp will drive out 4ohm power rating. If your speakers are 2 ohms, the amp will drive out 2 ohm power rating. However, do note that the 2ohm rating on amps are usually non-bridged. Most normal amps are not stable at 2ohm when bridging 2 channels into 1.

So far I've not come across car component speakers that are 2 ohms probably because the higher the impedence (ohm), the more control the speaker will sound. 2ohm components probably doesn't produce good controlled SQ. Some people use 8 ohm home audio speakers on cars as well.

是不是说2 ohms的喇叭会直接从amp那里接受2 ohms的power？